Fantech DBF4XLT Advanced Dryer Boosting Kit
Fantech introduces the most advanced Dryer Booster Fan in the industry . the DBF4XLT.
When it comes to dryers, where is the perfect installation with little to no duct length? The reality which contractors and homeowners have to work with is far from perfect. A short dryer duct length is not always possible. This is where Fantech Dryer Boosters can help.
Under prime conditions, residential and commercial clothes dryers should dry clothing in a timely fashion. Problems occur when dryers are connected to long runs of duct work. This is the reason why most residential dryers are located against outside walls. The exhausted air is vented directly to the outside without complicated ducting to hinder the performance of the dryer.
Many dryer installations do not allow direct venting and the typical residential dryer cannot operate efficiently against the resistance created by the necessary duct work. The results are longer drying times, higher energy usage and costs, and excessive wear and tear on the dryer.
Some common examples are:
Typical residential dryers are rated at 160cfm. However, boosting is generally needed in order to maintain a minimum airflow of 100cfm as duct length increases and bends are introduced in the duct line.
Based on surveying the recommendations from dryer manufacturers, and local building codes in selected areas, dryer boosting is typically required when the duct length exceeds the following:
Maximum duct length with:
No bends - 25'
1 bend - 20'
2 bends - 15'
3 bends - 10'
A Word on Installation...
The secret is in the fully automatic pressure switch. Designed to attach inline near the booster fan the switch monitors dryer operation and will activate the fan when the dryer comes on. Preset to cycle in ten minute intervals the fan will stay on until the dryer stops. All Fantech dryer booster fans are suitable for rigid duct runs of up to 60 linear feet with a maximum of six elbows. In all installations there needs to be at least 15 linear feet of duct between the booster fan and the dryer.