Print This Page
Brand:Airtec
Located in:Installation Supplies, Registers and Grilles, Airtec Diffusers and Grilles
MVAW Antique ceiling diffuser grille with adjustable collar. Product includes adjustable airflow damper - but no backdraft damper. See related products for backdraft dampers. The Model MV with its unique design and contractor friendly engineering saves money by reducing installation time by up to 80%. A Diffuser, Boot and Damper all in one, it installs in seconds with just a few easy steps. This new reproduction grille has the look and feel of cast iron, without the high cost and weight. FEATURES: - Will accept 6, 7, and 8 inch duct sizes using tear-away bands so there is no cutting required. - Mounting clips rotate into position securing the unit to the ceiling material quickly and easily. - A damper provides a virtually airtight shutoff, reducing drafts and condensation problems in cold climates - Includes 1 tie strap A= 11 1/4 B= 9 1/4 C= 5/16 D= 1 3/8 E= 3 1/4 F= 5 1/4 G= 7 1/4
Good for ceilings with square tiles.
By big al
from Decatur GA on 7/9/2008
from Decatur GA on 7/9/2008
Pros:
Attractive Design, Easily Understood Instructions, Easy Installation
Cons:
Plastic
Describe Yourself:
Homeowner
Bottom Line:
Yes, I would recommend this to a friend
Comments about Airtec AIRTEC MVAW Antique Diffuser Grille for 6/7/8" Duct:
I used these grilles in an old farmhouse that had 12" X 12" ceiling tiles. I wanted to fit a single grille within a single ceiling tile. The grilles, once installed, were attractive, but likely not as attractive as a similar product made of bronze or another metal. (That said, these grilles were less than 1/2 the cost of similar metal grilles.)