Print This Page
Customers most agreed on the following attributes:
from Antioch, CA on 2/2/2011
Comments about IAQ Motor Replacement for Spring Return Dampers - Model 78G1001:
Tip of shaft was rubbing against damper assembly. Shaft was too long, had to use extra washers and longer screws to pull it away from damper. Pin in shaft was too small, had to use existing pin and drill to enlarge pin hole.
from Indiana on 2/1/2011
Comments about IAQ Motor Replacement for Spring Return Dampers - Model 78G1001:
Works the same as new
from Modesto, CA on 1/13/2010
Comments about IAQ Motor Replacement for Spring Return Dampers - Model 78G1001:
Product is good but not what I needed as it rotates clockwise and I needed a counterclockwise rotating part.
from Sheffield,Mass. on 2/9/2009
Comments about IAQ Motor Replacement for Spring Return Dampers - Model 78G1001:
I saved $900 by finding these "they don't make them anymore" damper motors. [...] Thanks very much !!!!
from Virginia on 1/29/2009
Comments about IAQ Motor Replacement for Spring Return Dampers - Model 78G1001:
This driver motor saved me hundreds, as the zone damper is fine, only the driver motor had failed.Two screws, two wires and the job was done.My alternatives were complete damper assemblies, at the average cost of $225.00 each.
from Advance, NC on 1/20/2009
Comments about IAQ Motor Replacement for Spring Return Dampers - Model 78G1001:
Quick,[...]