Print This Page
Brand:
Jackson Systems
Located in:
Dampers, Dampers By Brand, Jackson Systems, Jackson Systems Stand Alone Dampers
Zone OneT is a two position stand-alone zone control damper assembly designed to solve isolated over-heating and over-cooling problems. An entire building can also be controlled by multiple Zone OneT dampers. This damper can be used to control a single room, or by using a number of dampers, zone multiple rooms. The duct sensor, auto changeover control and zone damper motor are pre-wired at the factory. Simply run two wires from a 24 volt transformer, three wires from the thermostat, and you are in business! Sequence of Operation The Zone OneT thermostat signals the damper to open or close. Warm or cool air is delivered depending on whether the automatic changeover sensor (located on the damper) senses warm or cool air in the supply duct. The green LED on the printed circuit board indicates the damper is in the open position. NOTE: The HVAC unit must be controlled by its own space thermostat or discharge air controller. Do not install a Zone OneT thermostat and damper in the area where the equipment space thermostat is located. Damper Features Available in round or rectangular Powered open/spring closed Auto changeover (set at 72 degrees F) Minimum position adjustment 24 Volt AC motor LED status indication of damper position Pre-wired controls from factory No control panel required Clone dampers available Most orders shipped the same day 5 year warranty Specifications Construction: 22 Ga. Galvanized Steel Linkage: Direct Drive Length: 10" Motor Voltage: 24 Volts AC, 50/60 Hz, 6.5 Watts, 7VA Torque: 35 in-oz to 55 in-oz Temperature Rating: 0 degrees F to 120 degrees F Operating Humididty: 5% to 95% Non-Condensing Timing: 30 Sec. Powered, 8 Sec. Spring Return Static Pressure: Maximum 1.0" W.C."
simple and effective
By tod
from Frisco, TX on 1/27/2010
from Frisco, TX on 1/27/2010
Pros:
Easily Understood Instructions, Easy Installation
Describe Yourself:
Professional
Bottom Line:
Comments about Jackson Systems 10" Round Zone One Damper Assembly D-Z1-10:
Very good damper. I used it to even out a bedroom zone, one bedroom was closer to the unit by 20' causing it to alway be much cooler in the summer and very hot in the winter. This damper has its own thermostat and transformer so it works independent from the air handler. The thermostat does not control the air handler only the damper. I received an estimate for a true zone system and it was $700.00 to $800.00. This do it your self damper was just over $300.00 with all the parts and it work great.
Thank you